Material : Flame-resistant EPS
Size : 520 * 520 * 25 (mm)
Use : It forms a route to the heating pipe, and the support pin distributes the load and prevents the floor from sinking.

Material : PE-RT
Size : 12(external diameter)X9(internal diameter) 1 Roll 70M
Use : The water within the pipe flows and heats up the floor, and the radiant heat warms up the air.

Material : Stone
Size : 520 * 1040 * 4 (mm)
Use : It supplements the pre-existing galvanized steel sheet’s weaknesses such as durability, intensity, constructability and heat conduction.

Material : GI
Size : 500 * 600 * 0.75 (mm)
Use : Since the adhesion is conducted as it demonstrates prompt heat conduction and stable load distribution, its hardness is guaranteed.

Adhesive
Capacity :10kg is the right amount for approximately 10 pyeong.
(The amount used varies depending on the floor status.)
Use : Since it is thinner than any pre-existing adhesive, it makes the construction process more convenient and prevents creating bumpy spots on the floor.

Adhesive
Capacity : 4kg is the right amount for approximately 10 pyeong.
Use : The module sheet and heat sink and bonded together to prevent noises as well as to enhance heat conductivity.
In addition, since the viscosity continuously remains, the heat sink will re-stick even after it comes apart.

Distributor
Material : Stainless
Use : It distributes the water within the heating pipe and circulates the water.
1 distributor requires 3 pyeong.